|
Williams Propane
and Natural Gas Heaters
|
Not sure what size heater you need for your greenhouse? Use our Heater
BTU Calculator.
Williams Heaters are Proudly Made in the USA.
Williams
Direct Vent Gas Heaters
|
|
Sealed
Combustion & No Electricity Required!
With these gas heaters, the direct wall vent draws outside air to the sealed combustion
chamber and vents exhaust gases directly outside. This feature is highly recommended
if you grow orchids. No electricity required, so heater will continue to operate
normally even during an electrical power outage. Included wall thermostat provides
precise heating control. Great heating option for greenhouses, garages, rooms
in homes, and work shops.
Williams Direct-Vent heaters are designed for quiet operation. Convenient, Piezo
pilot ignition - simple push button system lights the pilot without matches. 100%
safety shutoff. Compact cabinet takes up little space, projects into room less
than 11". (Largest heater is 32" wide x 28" high.) Vent pipe, and vent cap included. The optional
Blower increases air flow and distribution of heat. It can be added at any
time. Designed for propane or natural gas. Mounting bracket included. |
Models
|
BTU
Input |
BTU
Output |
1403821 (LP)
1403822 (NG)
|
14,000 |
9,800 |
2203821 (LP)
2203822 (NG) |
22,000 |
16,462 |
3003821 (LP)
3003822 (NG) |
30,000 |
21,000 |
Model 2303
Williams Blower
|
|
Blower
for Williams 14,000 BTU heater
This 125 CFM blower is a recommended option which directs the hot air
coming out of the top of the heater downward where you need it. It can be added
at any time. Includes prewired 6 ft. power cord. Requires 110/120v electricity.
Does not impede heater from running when power is off. This blower sits on top
of the heater and has an On/Auto/Off switch.
ON - blower stays
on continuously
AUTO - blower comes on when unit heats up and cuts off when it cools down
OFF - blower is always off
|
Model 2302
Williams Blower
|
|
Blower
for Williams 22,000 & 30,000 BTU heaters
This 135 CFM blower is a recommended option which directs the hot air
coming out of the top of the heater downward where you need it. It can be added
at any time. Includes prewired 6 ft. power cord. Requires 110/120v electricity.
Does not impede heater from running when power is off. This blower mounts inside
the heater cover and has an On/Off switch with pull chain and adjustable thermostat.
Thermostat range is 90° to 130°.
|
Model 9307
Thin-Wall Collar Kit
|
|
This kit extends the vent cap away from the exterior wall which is
needed when mounting the vent cap to vinyl siding or greenhouse coverings to prevent
heated exhaust air from damaging those materials. The thin-wall collar is also
used needed when venting through walls less than 4 1/2" thick.
|
Heating | Venting
| Misting | Lights | Controls
| Benches | Meters
Watering | Electrical
| Plastic | PVC | Books
| Containers | Other
ACF Greenhouses
380 Greenhouse Drive
Buffalo Junction, VA 24529
434-374-2706 Phone, 434-374-2055 Fax
888-888-9050 Toll Free
Copyright Aarons Creek Farms, Inc. All Rights Reserved.
|